SunTech ST4940 - Parameter Report

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
47 of 52
PWR_VOLT
String
Voltage of Battery in percentage (%)
RESERVED
EMPTY
ALERT_ID
1 char.
Alert type
1 = Start driving faster than SPEED_LIMIT.
2 = Ended over-speed condition.
5 = The vehicle went out from the geo-fence that has following ID.
6 = The vehicle entered into the geo-fence that has following ID
33: Motion On
34: Motion Off
52 = Low Battery.
56 = Magnet Connection Alert
57 = Magnet Disconnection Alert
70 = Shutdown by Power Key or CMD
RESERVED
EMPTY
RESERVED
EMPTY
MSG_TYPE
1 char
Report is made in real time (1); Report is in storage (0).
<Example>
ST600ALT;0123456789;30;309;20160729;09:06:27;024d7424;450;5;0014;22;+37.479317;+126.887835;000.00
0;000.00;0;0;38;100;;56;;;1
Examples for geo-fence
Into circular geo-fence group 2
ST600ALT;0123456789;30;309;20160725;05:49:19;024d7424;450;5;0014;22;+37.479312;+126.887846;000.00
9;000.00;12;1;0;100;;6002;;;1
Out from circular geo-fence group 1
ST600ALT;0123456789;30;309;20160725;05:49:19;024d7424;450;5;0014;22;+37.479312;+126.887846;000.00
9;000.00;12;1;0;100;;5001;;;1
<Note>
If the network is not fine then Alert 70 will be sending after turn ON.
11-4. Parameter Report
“Parameter Report” is sent by device for informing with device IP address to server.