SunTech ST4940 - Command on How to Setting the Movement Distance; Command on How to Initialize Message Number; Command on How to Initialize Circular Geo-Fence

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
32 of 52
Field
Marks
Value
Meaning
CMD_ID
EraseAll”
This command is used if you want to erase all the saved
reports and disable the outputs.
This command is needed to initialize the device which is to be
delivered to a new customer.
<Example>
[command] ST600CMD;0123456789;02;EraseAll
[response]ST600CMD;Res;0123456789;309;EraseAll
10-2. Command on how to setting the movement distance.
This command is used if you want to set the movement distance..
Field
Marks
Value
Meaning
COMMAND
“SetDist”
meter
Setting movement distance. This command is either followed
by “=” .Max value = “999999999”
<Example>
[command]
ST600CMD;0123456789;02;SetDist=100
[response]
ST600CMD;Res;0123456789;309;SetDist
10-3. Command on how to initialize Message Number
This command is used if you want to initialize sequence number of the message.
Field
Mark
Value
Meaning
CMD_ID
“InitMsgNo”
Set message number to 0.
<Example>
[command]
ST600CMD;0123456789;02;InitMsgNo
[response]
ST600CMD;Res;0123456789;309;InitMsgNo
10-4. Command on how to initialize Circular Geo-fence
● This command is used for erasing all circular geo-fence setting data.