55
The CAN-ID 1 is automatically assigned to
the master. This means the slave can be
assigned the IDs from
2 to 99.
Commissioning cannot be continued until
an ID has been requested from the main
unit.
2. Completion of commissioning
Confirm overview with .
3. Carry out commissioning for all other
slaves as described above.
Later commissioning
If you add new unit or replace existing
ones in your solar system, then you can
display the unit list in the display on the
main unit under «Settings – Network
– CAN bus». The new unit can them be
put into operation in accordance with
the description for commissioning sec
-
ondary units.
To Next Page
Loading...
