6-1-30 ENGINE GENERAL INFORMATION AND DIAGNOSIS (H25 ENGINE)
TRANS RANGE Ignition switch ON, selector lever is at “R”, “N”, “D”, “2” or “L”
range.
R, N, D, 2 or L ✱
BRAKE SW (Brake,
Stop Lamp, Switch)
Ignition switch ON, brake pedal is released. OFF
✱
Ignition switch ON, brake pedal is depressed. ON
O/D OFF SW
(Overdrive Cut Switch)
Ignition switch ON, overdrive cut switch OFF OFF
✱
Ignition switch ON, overdrive cut switch ON ON
MODE SELECT SW
(Power/Normal Change
Switch)
Ignition switch ON, P/N change switch is at normal position. NORMAL
✱
Ignition switch ON, P/N change switch is at power position. POWER
4WD-L SW
(4WD Low Switch)
Ignition switch ON, transfer lever is shifted at “4H” or “2H”
position.
OFF
✱
Ignition switch ON, transfer lever is shifted at “4L” position. ON
O/D & TCC OFF SIG Ignition switch ON, vehicle stops. OFF ✱
BLOWER FAN Ignition switch ON, blower fan switch OFF OFF
Ignition switch ON, blower fan switch ON ON
A/C CONDENSER FAN A/C is not operated. OFF
A/C is operated. ON
SCAN TOOL DATA CONDITION
NORMAL CONDITION/
REFERENCE VALUE
OTHER
To Next Page
Loading...
