ENGINE MECHANICAL (G16 ENGINE) 6A1-11
2) Install cylinder head cover to cylinder head and tighten cover
bolts to specified torque.
Tightening torque
Cylinder head cover bolt
(a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
3) Fix accelerator cable with clamp.
4) Install ignition coil assemblies with high-tension cord.
5) Connect PCV valve and breather hose to head cover.
6) Connect negative cable at battery.
Throttle Body and Intake Manifold
COMPONENTS
NOTE:
When installing cylinder head cover, use care so that cyl-
inder head cover gasket or O-rings will not get out of
place or fall off.
1. Intake manifold 4. Intake manifold stiffener (Front) 7. Throttle body 10. Manifold absolute pressure
(MAP) sensor
2. Gasket 5. Engine hook 8. Intake manifold stiffener (Rear) Do not reuse.
3. Intake manifold No.2 stiffener 6. Fuel delivery pipe 9. EGR valve
To Next Page
Loading...
