6A2-20 ENGINE MECHANICAL (H25 ENGINE)
10) Connect negative cable to battery.
11) Upon completion of installation, start engine and check that
no exhaust gas leakage exists.
Cylinder Head Covers
COMPONENTS
REMOVAL
1) Remove throttle body and intake manifold.
Refer to “Throttle Body and Intake Manifold” in this section
for removal.
2) Remove ignition coil covers.
3) Disconnect ignition coil couplers and remove ignition coils.
4) Remove cylinder head covers (1).
1. Cylinder head cover 4. Cylinder head cover side seal 7. Ignition coil cover Do not reuse
2. Cylinder head gasket 5. Cylinder head cover nut 8. Ignition coil cover screw
3. Spark plug pipe O-ring 6. Cylinder head cover seal washer Tightening torque
2. Nut
3. Seal washer
4. Cylinder head cover gasket
11 N·m (1.1 kg-m)
6
5
8
7
1
4
3
2
To Next Page
Loading...
