ENGINE MECHANICAL (G16 ENGINE) 6A1-31
10) Refill engine with engine oil referring to item “Engine Oil and
Filter Change” in Section 0B.
11) Refill front differential housing with gear oil referring to “Main-
tenance Service” in Section 7E.
12) Connect negative cable at battery.
13) Verify that there is no coolant leakage and each oil leakage
at each connection.
14) After completing installation, check oil pressure by running
engine.
Rocker Arms, Rocker Arm Shaft and Camshaft
1. Camshaft 10. Valve adjusting screw 19. Camshaft housing No.5
2. Camshaft oil seal 11. Clip 20. Camshaft housing No.6
: Apply sealant 99000-31110 to mating surface of housing and cylinder head.
3. Rocker arm shaft 12. Lock nut 21. CMP sensor case
: Apply sealant 99000-31110 to hatched part as shown in figure.
4. O-ring 13. Rocker arm spring 22. O-ring
5. Rocker shaft bolt 14. Camshaft housing bolt Tightening torque
6. Rocker arm (IN) 15. Camshaft housing No.1 Do not reuse.
7. Rocker arm No. 1 (EX) 16. Camshaft housing No.2 : Apply engine oil to sliding surface of each part.
8. Rocker arm No. 2 (EX) 17. Camshaft housing No.3
9. Valve adjusting screw 18. Camshaft housing No.4
12 N·m (1.2 kg-m)12
12 N·m
(1.2 kg-m)
12
11 N·m
(1.1 kg-m)
5
1
11 N·m (1.1 kg-m)12
11 N·m (1.1 kg-m)14
16
2
4
22
20
3
8
7
6
9
15
17
18
19
21
13
11
13
10
To Next Page
Loading...
