ENGINE AND EMISSION CONTROL SYSTEM (G16/J20 ENGINES) 6E1-49
2) Install crankshaft position sensor to oil pan.
Tightening torque
Crankshaft position sensor bolt
(a) : 10 N·m (1.0 kg-m, 7.5 lb-ft)
3) Connect connector to it securely.
Crankshaft position sensor (J20 engine)
INSPECTION
Check crankshaft position sensor referring to Steps 2 and 3 of
“DTC P0335 Diag. Flow Table” in Section 6. If malfunction is
found, replace.
REMOVAL
1) Remove transmission from vehicle and then remove flywheel
or drive plate from crankshaft.
2) Disconnect connector from crankshaft position sensor (1).
3) Remove crankshaft position sensor from cylinder block (2).
INSTALLATION
Reverse removal procedure noting the following.
• Check to make sure that crankshaft position sensor is free
from any metal particles and damage.
• Apply engine oil to O-ring of sensor.
• Install crankshaft position sensor to cylinder block.
Tightening torque
Crankshaft position sensor bolt
(a) : 6 N·m (0.6 kg-m, 4.5 lb-ft)
• Connect connector and fix wire harness with clamp securely.
Manifold absolute pressure (MAP) sensor
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect connector from MAP sensor.
3) Remove MAP sensor from intake manifold.
CAUTION:
Be sure to tighten to specified torque. CKP sensor will be
deformed if overtightened and correct CKP sensor signal
will not be fed if loosened.
To Next Page
Loading...
