6-56 ENGINE GENERAL INFORMATION AND DIAGNOSIS (G16/J20 ENGINES)
Table A-1 Malfunction Indicator Lamp Circuit Check – MIL Does Not Come
“ON” or Dims at Ignition Switch On (But Engine at Stop)
WIRING DIAGRAM
CIRCUIT DESCRIPTION
When the ignition switch is turned ON, ECM causes the main relay to turn ON (close the contact point). Then,
ECM being supplied with the main power, turns ON the malfunction indicator lamp (MIL). When the engine
starts to run and no malfunction is detected in the system, MIL goes OFF but if a malfunction was or is detected,
MIL remains ON even when the engine is running.
[A] : Canvas top model 1. ECM (PCM) 3. Main fuse 5. Monitor connector (if equipped)
[B] : Other than canvas top model 2. To ignition switch 4. Main relay 6. MIL
6
5V
To Next Page
Loading...
