6E2-44 ENGINE AND EMISSION CONTROL SYSTEM (H25 ENGINE)
Main relay
INSPECTION
1) Disconnect negative cable at battery.
2) Remove main relay (1) from connector.
3) Check resistance between each two terminals as in table
below.
If check results are as specified, proceed to next operation
check. If not, replace.
Main relay resistance
4) Check that there is continuity between terminals “A” and “B”
when battery is connected to terminals “C” and “D”.
If malfunction is found, replace.
[A] : Left-hand steering vehicle
[B] : Right-hand steering vehicle
[A]
[B]
1
1
TERMINALS RESISTANCE
Between A and B
∞
(Infinity)
Between C and D 160 – 240
Ω
at 20°C, 68°F
To Next Page
Loading...
