6E1-58 ENGINE AND EMISSION CONTROL SYSTEM (G16/J20 ENGINES)
INSTALLATION
Reverse removal procedure noting following.
• Clean mating surface of EGR valve (1) and intake manifold
(3).
• Use new gasket (2).
Evaporative emission control system
VACUUM PASSAGE INSPECTION
Start engine and run it at idle speed. With finger placed against
vacuum nozzle (1), check that vacuum is applied.
If it is not applied, clean vacuum passage by blowing compressed
air.
VACUUM HOSE INSPECTION
Check hoses for connection, leakage, clog and deterioration.
Replace as necessary.
[A] : G16 Engine
[B] : J20 Engine
To Next Page
Loading...
