6C-8 ENGINE FUEL
8) Connect fuel filter inlet hose (3) to fuel filter (1).
9) Connect coupler to fuel pump assembly and tank pressure
sensor respectively.
10) Connect negative (–) cable to battery.
11) Upon completion of installation, check fuel system for leak-
age.
Fuel Tank Purging Procedure
The following procedure is used for purging the fuel tank.
1) After removing fuel tank, remove all hoses and fuel pump
assembly from fuel tank.
2) Drain all remaining fuel from tank.
3) Move tank to flushing area.
4) Fill tank with warm water or tap water, and agitate vigorously
and drain. Repeat this washing until inside of tank is clean.
Replace tank if its inside is rusty.
5) Completely flush out remaining water after washing.
Tightening Torque Specification
2. Fuel filter outlet hose
CAUTION:
This purging procedure will NOT remove all fuel vapor.
Do not attempt any repair on tank where heat or flame is
required, as an explosion resulting in personal injury
could occur.
Fastening part
Tightening torque
N•m kg-m lb-ft
Fuel pump assembly bolt 5.0 0.5 3.5
Fuel tank bolt
50 5.0 36.5
Fuel tank protector bolt
Breather hose clamp 2.0 0.2 2.0
Fuel filler hose clamp 4.0 0.4 3.0
To Next Page
Loading...
