CRANKING SYSTEM (0.9 kW, 1.2 kW and 1.4 kW Reduction Type) 6G-15
9. PINION AND OVER-RUNNING CLUTCH
• Inspect pinion for wear, damage or other abnormal condi-
tions.
Check that clutch locks up when turned in direction of drive
and rotates smoothly in reverse direction. Replace if neces-
sary.
• Inspect spline teeth for wear or damage. Replace if neces-
sary.
Inspect pinion for smooth movement.
10. FRONT HOUSING BUSH
Inspect bush for wear or damage. Replace if necessary.
Performance Test
Pull-In Test
Connect battery to magnetic switch as shown.
Check that plunger and pinion move outward.
If plunger and pinion don't move, replace magnetic switch.
CAUTION:
Each test must be performed within 3 – 5 seconds to
avoid coil from burning.
NOTE:
Before testing, disconnect lead wire from terminal M.
1. Terminal ‘S’
2. Terminal ‘M’
3. Lead wire (switch to motor)
4. Terminal “B”
To Next Page
Loading...
