6F2-12 IGNITION SYSTEM (FOR J20/H25 ENGINES)
INSTALLATION
1) Install spark plug(s) (3) and tighten them to specified torque.
Tightening torque
Spark plug (a) : 25 N·m (2.5 kg-m, 18.0 lb-ft)
2) Install ignition coil assembly (2) securely.
3) Tighten ignition coil bolt (1), and then connect ignition coil
coupler.
4) For H25 engine, install ignition coil cover.
CMP Sensor
REMOVAL
1) Disconnect CMP sensor coupler (2).
2) Remove CMP sensor (1) by removing bolt(s) (3).
[A] : J20 Engine
[B] : H25 Engine
CAUTION:
Disassembly is prohibited. If anything faulty is found,
replace as an assembly unit.
[A] : J20 Engine
[B] : H25 Engine
To Next Page
Loading...
