6C-4 ENGINE FUEL
INSTALLATION
Reverse removal procedure noting the following.
• Upon completion of installation, verify that there is no fuel
leakage at each connection referring to Section 6 or Section
6-1.
Fuel Lines
1. Fuel filter
2. Fuel filter outlet hose
3. Fuel filter inlet hose
NOTE:
Due to the fact that fuel feed line is under high pressure,
this system requires special consideration for service.
The feed pipe uses screw couplings and hose clamps.
1. To delivery pipe
2. Fuel tank
3. Fuel filter
4. Steering gear box
5. Front drive shaft
1
3
2
5
4
To Next Page
Loading...
