6A1-14 ENGINE MECHANICAL (G16 ENGINE)
• Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
• Refill cooling system referring to “Cooling System Flush and
Refill” in Section 6B.
• Adjust water pump drive belt tension referring to “Cooling
Fan Belt Tension Check and Adjustment” in Section 6B.
• Upon completion of installation, turn ignition switch ON but
engine OFF and check for fuel leaks.
• Finally, start engine and check for engine coolant leaks.
Exhaust Manifold
COMPONENTS
[A] : Vehicle not equipped with warm up three way catalytic converter 3. Gasket 7. Engine hook
[B] : Vehicle equipped with warm up three way catalytic converter 4. Heated oxygen sensor-1 8. Heated oxygen sensor-2 connector
1. Exhaust manifold 5. Lower cover Tightening torque
2. Upper cover 6. Exhaust manifold stiffener Do not reuse.
WARNING:
To avoid danger of being burned, do not service exhaust system while it is still hot. Service should be
performed after system cools down.
To Next Page
Loading...
