Suzuki Engine 2002 GRAND VITARA SQ625 - Ignition Timing Adjusting Resistor (if Equipped); CMP Sensor

6F1-14 IGNITION SYSTEM (FOR G16 ENGINE)
Ignition Timing Adjusting Resistor (If
Equipped)
REMOVAL
1) With ignition switch OFF, remove ECM (or PCM), referring to
“Engine Control Module (ECM)/Power Train Control Module
(PCM)” in Section 6E1.
2) Remove ignition timing adjusting resistor (2).
INSPECTION
Measure resistance of ignition timing adjusting resistor by using
ohmmeter.
If check result is not satisfactory, replace ignition timing adjusting
resistor.
INSTALLATION
For installation, reverse removal procedure.
CMP Sensor
Refer to “Camshaft Position Sensor (CMP Sensor)” in Section
6E1 for removal, inspection and installation.
1. Noise suppressor
NOTE:
Depending on number marked on ignition timing adjust-
ing resistor, resistor value varies as follows.
1 : 0
Ω
6 : 980 – 1020
Ω
2 : 80 – 84
Ω
7 : 1.47 – 1.53 k
Ω
3 : 157 – 163
Ω
8 : 2.16 – 2.24 k
Ω
4 : 265 – 274
Ω
9 :3.53 – 3.67 k
Ω
5 : 421 – 439
Ω
10 : 6.08 – 6.32 k
Ω
N : 666 – 694
Ω
11 : 11.8 – 12.2 k
Ω
1. CMP sensor