ENGINE GENERAL INFORMATION AND DIAGNOSIS (G16/J20 ENGINES) 6-33
MODE SELECT SW (POWER/NORMAL CHANGE SWITCH, POWER/NORMAL)
POWER : Switch button is at POWER position.
NORMAL : Switch button is at NORMAL position.
4WD-L SW (4WD-LOW SWITCH, ON/OFF)
ON : Transfer lever is shifted to 4L position.
OFF : Transfer lever is shifted to 4H or 2H position.
Visual Inspection
Visually check following parts and systems.
INSPECTION ITEM REFERRING SECTION
• Engine oil ----- level, leakage Section 0B
• Engine coolant ----- level, leakage Section 0B
• Fuel ----- level, leakage Section 0B
• A/T fluid ----- level, leakage Section 0B
• Air cleaner element ----- dirt, clogging Section 0B
• Battery ----- fluid level, corrosion of terminal
• Drive belt ----- tension, damage Section 0B
• Throttle cable ----- play (after warm up engine), installation Section 6E1/6E2
• Vacuum hoses of air intake system ----- disconnection, loose-
ness, deterioration, bend
• Connectors of electric wire harness ----- disconnection, friction
• Fuses ----- burning Section 8
• Parts ----- installation, bolt ----- looseness
• Parts ----- deformation
• Other parts that can be checked visually
Also add following items at engine start, if possible.
• Malfunction indicator lamp (Operation) Section 6
• Charge warning lamp (Operation) Section 6H
• Engine oil pressure warning lamp (Operation) Section 8 (Section 6A1/6A4 for pressure
check)
• Engine coolant temp. meter (Operation) Section 8
• Fuel level meter (Operation) Section 8
• Abnormal air being inhaled from air intake system
• Exhaust system ----- leakage of exhaust gas, noise
• Other parts that can be checked visually
To Next Page
Loading...
