ENGINE MECHANICAL (J20 ENGINE) 6A4-15
Cylinder Head Cover
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect ignition coil couplers.
3) Remove ignition coils.
4) Disconnect accelerator cable from clamp (For LH steering
vehicle only).
5) Remove oil level gauge (1).
6) Disconnect breather hose (2) and PCV hose (3) from cylin-
der head cover.
7) Remove cylinder head cover.
INSTALLATION
1) Remove oil, old sealant, and dust from sealing surfaces on
cylinder head and cover.
2) Install O-rings (3) and cylinder head cover gasket (2) to cylin-
der head cover (1).
3) Install cylinder head side seal (4) to cylinder head.
4) After cleaning, apply sealant “A” to cylinder head sealing sur-
face area as shown in figure.
“A” : Sealant 99000-31250
NOTE:
Be sure to check each of these parts for deterioration or
any damage before installation and replace if found
defective.
To Next Page
Loading...
