6A4-62 ENGINE MECHANICAL (J20 ENGINE)
d) Tighten all bolts to 53 N·m (5.3 kg-m, 38.5 lb-ft) according
to numerical order in figure.
e) In the same manner as in 4) again, tighten them to speci-
fied torque.
Tightening torque
Cylinder head bolt (a) : 105 N·m (10.5 kg-m, 76.0 lb-ft)
Cylinder head bolt (M6) (b) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
5) Check that key (2) on crankshaft aligns with timing mark (1)
as shown in figure.
6) Reverse removal procedure for installation.
7) Adjust cooling fan belt tension referring to “Cooling Fan Belt
Tension Check and Adjustment” in Section 6B for adjusting
procedure.
8) Adjust accelerator cable play and A/T throttle cable play (for
vehicle with A/T) referring to “Accelerator Cable Adjustment”
and “A/T Throttle Cable Adjustment” in Section 6E1.
9) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
10) Refill engine with engine oil referring to “Engine Oil and Filter
Change” in Section 0B.
11) Refill cooling system referring to “Cooling System Flush and
Refill” in Section 6B.
12) Refill front differential housing with gear oil referring to “Main-
tenance Service” in Section 7E.
13) Refill power steering system with specified fluid referring to
“Power Steering Fluid” in Section 3B1.
14) Connect negative cable at battery.
15) Verify that there is no fuel leakage, coolant leakage, oil leak-
age and exhaust gas leakage at each connection.
16) Check ignition timing and adjust as necessary referring to
“Ignition Timing Check and Adjustment” in Section 6F2.
NOTE:
Be sure to tighten M6 bolt (3) after securing the other
bolt.
1. Crankshaft pulley side
2. Flywheel side
To Next Page
Loading...
