1A-132 Engine General Information and Diagnosis:
2 1) Turn the ignition switch ON.
2) Measure the voltage between the O/W wire and ground.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage ( )
EVAP system purge control valve voltage
Battery voltage
((+) terminal: O/W – (–) terminal: Ground)
Is the voltage OK?
• W/Y wire open or
shorted to the
ground, or poor “15”
connection failure.
• If wire and
connection are OK,
intermittent trouble or
faulty ECM.
• Recheck each
terminal and wire
harness for open
circuit and poor
connection.
• Replace the ECM
with a known good
one, and inspect it
again. Refer to “ECM
Removal and
Installation in Section
1C (Page 1C-2)”.
Open or short circuit in
the O/W wire.
Step Action Yes No
V
(A)
I718H2110003-01
To Next Page
Loading...
