Brake Control System and Diagnosis: 4A-7
7) Close the air bleeder valve (1) and disconnect the
clear hose.
Tightening torque
Air bleeder valve (Front) (a): 6 N·m (0.6 kgf-m,
4.5 lb-ft)
8) Fill the reservoir with brake fluid.
9) Install the reservoir cap.
Rear Brake
1) Place the motorcycle on a level surface.
2) Remove the right frame cover. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)”.
3) Remove the brake fluid reservoir cap and
diaphragm.
4) Suck up the old brake fluid as much as possible.
5) Fill the reservoir with new brake fluid.
BF: Brake fluid (DOT 4)
6) Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
7) Loosen the air bleeder valve and pump the brake
pedal until the old brake fluid flows out of the brake
system.
(a)
1
I823H1410014-02
I823H1410044-01
I823H1410015-01
I823H1410016-02
I823H1410017-01
To Next Page
Loading...
