Brake Control System and Diagnosis: 4A-11
2) Remove the brake lever (4) and brake light switch
(5).
3) Pull out the dust boot (6) and push rod (7).
4) Remove the snap ring (8).
Special tool
: 09900–06108 (Snap ring pliers)
5) Remove the following parts from the master cylinder.
• Secondary cup (9)
• Piston (10)
• Primary cup (11)
• Spring (12)
• Spring guide (13)
Assembly
Assemble the master cylinder in the reverse order of
disassembly. Pay attention to the following points:
CAUTION
!
• Wash the master cylinder components with
new brake fluid before reassembly.
• Do not wipe the brake fluid off after
washing the components.
• When washing the components, use the
specified brake fluid. Never use different
types of fluid or cleaning solvents such as
gasoline, kerosine, etc.
• Apply brake fluid to the master cylinder
bore and all of the master cylinder
component to be inserted into the bore.
BF: Brake fluid (DOT 4)
• When install the spring guide, fit the convex part “A” of
the spring guide into the concave part “B” of the
master cylinder.
4
5
I823H1410023-01
7
6
8
I823H1410025-01
9
10
11
12
13
I823H1410026-01
I823H1410027-02
“A”
“B”
I823H1410028-02
To Next Page
Loading...
