Suzuki GSX1300BK B-King - Page 632

Wiring Systems: 9A-8
2
3
4
5
6
10
9
1
5
4
3
1
2
6
“A”
C
B
A
7
“B”
8
“a”
“C”
“D”
I823H1910906-07
1. Clutch hose 9. Clamp
: Bind the clutch hose and left handlebar switch lead wires. Cut off the
excess end of the clamp.
2. Left handlebar switch lead wire 10. Clamp
: Bind the front brake hose and right handlebar switch lead wires. Cut off
the excess end of the clamp.
3. Right handlebar switch lead wire “A”: Push in the cap and turn it to set the ON position to the top.
4. Throttle cable No. 1 “B”: When installing the immobilizer antenna, tighten the screws in this order
(A o B o C).
5. Throttle cable No. 2 “C”: Make sure that the distance between throttle cable adjuster top and
brake lever adjuster is 55 mm (2.16 in) or less.
6. Front brake hose “D”: Pass the left and right handlebar switch harnesses behind the headlight
brace.
7. Immobilizer antenna (For E-02, 19, 24) “a”: 55 mm (2.16 in) or less
8. Cushion seat
: Stick the cushion seat to the back side of the ignition switch cap
properly.