Suzuki LT-Z90K7 2007 - Page 104

3-60 ENGINE
• Remove the spiral spring
9
from the recoil starter case
0
.
REASSEMBLY
Reassemble the recoil starter in the reverse order of disassem-
bly. Pay attention to the following points:
• When installing the spiral spring, hook the spiral spring end
1
with the recoil starter case.
#
• Apply SUZUKI SUPER GREASE “A” to the spiral spring.
X 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent)
• Turn the rope on the reel properly.
• After installing the spiral spring, engage the part
A
of the reel
with the spiral spring end
2
.
• Hook the rope onto the hook part
B
of the reel.
• Turn the reel counterclockwise three or four times with the
rope.
• Lace the end of the rope through the recoil starter case hole
C
.
• Tie a knot at the end of the rope.
• Install the cap
3
to the knob
4
.
Wear hand and eye protection when installing the reel,
since the spiral spring may quickly unwind and cause
an injury.