Suzuki LT-Z90K7 2007 - Page 55

ENGINE 3-11
• Remove the cylinder head nut
9
in diagonal stages, and then
remove the cylinder head
0
.
NOTE:
If the cylinder head does not come off easily, lightly tap it using a
plastic mallet.
CYLINDER
• Remove the cylinder head gasket
1
and dowel pins.
• Remove the cam chain guide
2
.
• Remove the cylinder
3
.
NOTE:
If the cylinder does not come off easily, lightly tap it using a plas-
tic mallet.
• Remove the cylinder gasket
4
and dowel pins.
PISTON
• Place a clean rag over the cylinder base to prevent the piston
pin circlip
1
from dropping into the crankcase.
• Remove the piston pin circlip
1
.