DISASSEMBLY AND ASSEMBLY 4-39
INSPECTION
• Inspect the clutch sleeve hub and primary driven gear for
wear and cracks.
• If any defects are found, replace the sleeve hub or driven gear
with a new one.
• Inspect the needle bearing and spacer for damage and wear.
• If any defects are found, replace the bearing or spacer with a
new one.
INSTALLATION
Install the primary driven gear and clutch sleeve hub in the
reverse order of removal. Pay attention to the following points:
• Apply engine oil to the spacer 1 and needle bearing 2.
• Install the spacer 1 and needle bearing 2.
• Install the primary driven gear 3.
• Install the washer 4.
To Next Page
Loading...
