Suzuki RM-Z250 - Hot Starter; Throttle Body

2-24 PERIODIC MAINTENANCE
HOT STARTER
Adjust the hot starter cable play as follows:
NOTE:
Be careful not to damage the lever cover when installing.
(5-18)
• Loosen the lock-nut 1.
• Turn adjuster 2 so the hot starter lever clearance A mea-
sured at the lever holder obtains 2 – 3 mm (0.08 – 0.12 in)
when squeezing the lever until pressure is felt.
• Tighten the lock-nut 1.
 Hot starter lever clearance A: 2 – 3 mm (0.08 – 0.12 in)
 Cable adjuster lock-nut: 2.2 N·m (0.22 kgf-m, 1.60 lbf-ft)
• Check that the hot starter lever moves smoothly from full open
to full close.
• If it does not move smoothly, lubricate the hot starter cable.
THROTTLE BODY
• Inspect the throttle body for dirt or mud. If any dirt or mud is
found, clean the throttle body.
NOTE:
Do not apply pressured water to the throttle body cover drain as
muddy water can get into cover.