1-4 GENERAL INFORMATION
OPERATING INSTRUCTIONS
STARTING THE ENGINE
Inspect the engine oil level, coolant level and air cleaner condi-
tion before starting the engine.
NOTE:
Check that the fuel tank has enough fuel for practice or race
before starting the engine.
When the engine is cold regardless of ambient temperature:
1) Shift the transmission into neutral.
2) Pull out the starter knob/idle screw 1.
NOTE:
When pulling the starter knob/idle screw 1, do not turn it.
3) Kick down the kick starter lever slowly from the top position
until engine compression resistance is felt, release the kick
starter lever from this position and allow it to return to the
top. While keeping the throttle closed, depress the kick
starter lever strongly through the full stroke. Never open the
throttle during the kick start operation.
NOTE:
When kick-starting the engine, remove the side stand.
4) Return the starter knob/idle screw 1 when the engine revs
at steady speed.
NOTE:
When the clutch lever is pulled, the motorcycle can be started
with the transmission in any gear.
NOTICE
Leaving the engine at idling speed after riding will cause engine overheat as this competition
motorcycle does not have the radiator cooling fan and coolant reservoir. Riding the motorcycle
under severe conditions such as muddy or sandy terrain with high ambient temperature can
shorten time to be overheated.
Do not leave the engine at idling after riding the motorcycle. Inspect the radiator for proper
coolant level before riding for practice and race.
To Next Page
Loading...
