Suzuki RM-Z250 - Replacement Parts

NOTE:
* Clean a motorcycle from dirt and/or dust before
servicing.
* Avoid spraying or allowing water to flow over the
following places:
- Spark plug
- Fuel tank cap
- Throttle body
- Fuel injection system
- Brake master cylinders
- Air cleaner inlet
* Be sure to dry the motorcycle after washing the
motorcycle. Blow off water from parts by applying
air blow if it is necessary to remove parts just after
washing the motorcycle.
REPLACEMENT PARTS
NOTE:
Use of replacement parts which are not equivalent
in quality to genuine SUZUKI parts can lead to per-
formance problems and damage.
Use only genuine SUZUKI replacement parts or
their equivalent. Genuine SUZUKI parts are high
quality parts which are designed and built specially
for SUZUKI motorcycle.
NOTICE
High pressure washers such as those
found at coin-operated car washes have
enough pressure to damage the parts of
your motorcycle. It may cause rust, corro-
sion and increase wear. Parts cleaner can
also damage motorcycle parts.
Do not use high pressure washers to clean
your motorcycle. Do not use parts cleaner
on throttle body and fuel injection sensors.