GENERAL INFORMATION 1-7
BREAK-IN (RUNNING-IN)
WHEN THE MOTORCYCLE IS NEW
1) Warm up the engine before starting off.
2) Ride for 60 minutes using less than 1/2 throttle opening.
3) Ride for 60 minutes using less than 3/4 throttle opening.
NOTE:
* The break-in (running-in) period is the period of greatest wear.
* The bolts and nuts of the new machine can loosen quickly. Be
sure to retighten the bolts and nuts during the break-in (run-
ning-in) period.
A CLOSED
B 1/2
C FULL OPEN
WHEN ENGINE PARTS ARE REPLACED
Follow the same procedure when any of the following parts are
replaced:
•Piston
• Piston ring
• Cylinder
• Crankshaft
• Crankshaft bearing
To Next Page
Loading...
