PERIODIC MAINTENANCE 2-15
ENGINE OIL FILTER CHANGE
• Drain the engine oil as described in the engine oil replace-
ment procedure.
• Remove the oil filter cap 1 and spring 2 with oil filter 3.
• Apply engine oil lightly to the gasket of new oil filter before
installation.
• Install the new oil filter.
• Apply engine oil lightly to the new O-ring.
NOTE:
Use the new O-ring to prevent oil leakage.
• Install the oil filter cap and tighten the bolts.
Oil filter cap bolt: 11 N·m (1.1 kgf-m, 8.0 lbf-ft)
• Add new engine oil and check the oil level as described in the
engine oil level inspection procedure.
Oil change .......... 950 ml (1.0/0.8 US/Imp qt)
Filter change ......1 000 ml (1.1/0.9 US/Imp qt)
Overhaul.............1 100 ml (1.2/1.0 US/Imp qt)
NOTICE
If the filter is installed improperly, serious engine dam-
age may result.
Make sure that the oil filter installed properly.
To Next Page
Loading...
