5-18 SERVICING INFORMATION
HOT STARTER LEVER INSTALLATION
*1
*5
*3
*4
*2
*1 Pass the hot starter cable into the lever cover.
*2 Connect the hot starter cable to the master cylinder holder and hot starter lever.
*3 Pass the hot starter lever into the lever cover.
*4
Tighten the lower bolt first temporarily to provide clearance on the upper side and then tighten both the bolts to
the specified torque.
*5 Install the cover of hot starter lever firmly. Be careful not to damage the lever cover when installing.
ITEM N·m kgf-m lbf-ft
A 12 1.2 8.5
B 10 1.0 7.0
To Next Page
Loading...
