Suzuki RM-Z250 - Inspection

4-64 DISASSEMBLY AND ASSEMBLY
BRAKE PADS REPLACEMENT
FRONT BRAKE PADS
• Remove the cap 1 and pad mounting pin 2.
• Remove the brake pads 3.
NOTE:
Replace the two brake pads as a set.
• Fit the new brake pads into the caliper.
• Tighten the pad mounting pin 2 to the specified torque.
 Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
NOTE:
Pump the brake lever several times to seat the brake pads after
reassembling.
REAR BRAKE PADS
• Remove the pad mounting pin 1.
• Remove the brake pads 2.
NOTE:
Replace the two pads as a set.
• Fit the new brake pads into the caliper.
• Apply SUZUKI SILICONE GREASE to the O-ring.
 99000-25100: SUZUKI SILICONE GREASE
or equivalent
• Tighten the brake pad mounting pin 1 to the specified torque.
 Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
NOTE:
Pump the brake pedal several times to seat the brake pads after
reassembling.