DISASSEMBLY AND ASSEMBLY 4-7
INSTALLATION
Install the engine in the reverse order of removal. Pay attention to the following points:
• Fit the swingarm in its position and hold it with the swingarm pivot shaft.
• Mount the engine on the frame.
• Tighten the engine mounting bolts, nuts and swingarm pivot shaft nut to the specified torque.
NOTE:
* The engine mounting nut is the self-lock type and cannot be used repeatedly. If the self-lock effect is lose,
replace it with a new one.
* The engine mounting bolts and nuts can loosen quickly when the engine is removed and installed. Be sure
to retighten the bolts and nuts.
ITEM N·m kgf-m lbf-ft a Shim
A 45 4.5 32.5
BC 66 6.6 47.5
D 70 7.0 50.5
EF 40 4.0 29.0
RHLH
To Next Page
Loading...
