Suzuki RM-Z250 - Oil Strainers; OIL STRAINER (No.1) REMOVAL; OIL STRAINER (No.2) REMOVAL

2-16 PERIODIC MAINTENANCE
OIL STRAINERS
OIL STRAINER (No.1) REMOVAL
• Hold the motorcycle upright.
• Clean the engine to avoid engine trouble.
• Drain engine oil. (2-14)
• Remove the oil strainer cap.
NOTE:
Hold the motorcycle upright while replacing the oil strainer.
• Pull out the oil strainer 1.
NOTE:
Inspect the feed pump side oil strainer (No.1) when the engine
oil is replaced.
OIL STRAINER (No.2) REMOVAL
• Drain engine oil. (2-14)
• Remove the gearshift lever.
• Remove the magneto cover. (4-51)
• Remove the oil pump No.2 cover 2 by removing their bolts
1.
• Remove the dowel pin 3.
• Remove the oil strainer No.2 5 by removing their bolts 4.