Suzuki RM-Z250 - Gearshifting

DISASSEMBLY AND ASSEMBLY 4-69
• Remove the brake pad. (4-64)
• Remove the spring 7.
• Remove the caliper bracket 8 from the caliper 9.
• Remove the boots 0 and A.
• Remove the spring B.
• Remove the rear brake caliper axle bolt (bracket) C.
• Wrap the caliper with a rag to prevent brake fluid scatter and
piston pop-out.
• Apply low-pressure air into the caliper through the hole to
remove the piston.
• Remove the dust seal D and piston seal E.
 CAUTION
Fingers can get caught between piston and caliper
body when removing the piston.
Do not place your fingers on the piston when remov-
ing the piston.