Symantec NetBackup - Changing Openstorage Storage Server Properties; Deleting an Openstorage Storage Server; Determining Openstorage Storage Server State

Changing OpenStorage storage server properties
You can change the OpenStorage storage server properties. The storage vendor
exposes the properties that you can change.
See “About OpenStorage storage servers” on page 61.
To change deduplication storage server properties
1
In the NetBackup Administration Console, expand Media and Device
Management > Credentials > Storage Server
2
Select the storage server.
3
On the Edit menu, select Change.
4
In the Change Storage Server dialog box, select the Properties tab.
5
To change a value, select it in the Value column and then change the value.
6
When finished changing values, click OK.
7
Click OK.
Deleting an OpenStorage storage server
If you delete a storage server, NetBackup removes it from your configuration.
If a disk pool is configured from the disk volumes that the storage server manages,
you cannot delete the storage server.
Warning: Do not delete a storage server if its storage contains unexpired NetBackup
images; if you do, data loss may occur.
To delete an OpenStorage storage server
1
In the NetBackup Administration Console, in the left pane, expand Media
and Device Management > Credentials > Storage
2
On the Edit menu, select Delete.
3
Click Yes in the confirmation dialog box.
Determining OpenStorage storage server state
Use the NetBackup nbdevquery command to determine the state of an OpenStorage
storage server.
To determine OpenStorage storage server status
◆
Run the following command:
Managing OpenStorage
Managing OpenStorage storage servers
106