To create the tpconfig command log directory
◆
Depending on the operating system, create the debug directory and the
tpcommand directory (by default, the debug directory and the tpcommand
directory do not exist). After you create the directories, the pathnames are
as follows:
UNIX: /usr/openv/volmgr/debug/tpcommand
Windows: install_path\Volmgr\debug\tpcommand
Configuring an OpenStorage storage server
Configure in this context means to add the storage host to NetBackup as a storage
server. When you configure a storage server, you also configure the media servers
that function as data movers.
If the storage host does not require logon credentials, you must enter dummy
credentials so that NetBackup configures the media servers as data movers.
To configure an OpenStorage storage server in NetBackup
1
In the NetBackup Administration Console, in the left pane, click Media and
Device Management.
2
In the right pane, select Configure Disk Storage Servers.
3
Follow the wizard screens to configure a storage server.
Setting the Nirvanix storage server properties
For Nirvanix storage, you must use the following procedure to set the storage
server properties during configuration. Set the properties after you configure the
storage server.
See “Nirvanix storage server properties” on page 86.
To change storage server properties
1
In the NetBackup Administration Console, expand Media and Device
Management > Credentials > Storage Server
2
Select the storage server.
3
On the Edit menu, select Change.
85Configuring OpenStorage
Configuring an OpenStorage storage server
To Next Page
Loading...
