Be sure to review the limitations of the wizard in the wizard help.
To start the Device Configuration Wizard
1
In the NetBackup Administration Console, expand Media and Device
Management.
2
Click Configure Storage Devices.
About adding Shared Storage Option configuration options
You can fine-tune your configuration by adding Shared Storage Option options
to the vm.conf Media Manager configuration file.
For more information, see "The Media Manager configuration file" in the following:
■ NetBackup Administrator’s Guide for UNIX and Linux, Volume II
■ NetBackup Administrator’s Guide for Windows, Volume II.
About configuring NetBackup storage units and backup policies
You must configure storage units and policies for your shared drives. If you used
the Device Configuration Wizard to configure the shared drives, you may have
configured storage units and policies already.
For more information, see the following:
■ NetBackup Administrator’s Guide for UNIX and Linux, Volume I
■ NetBackup Administrator’s Guide for Windows, Volume I.
Configure storage units and backup policies as follows:
In each storage unit definition, logically define the robot
and the shared drives for that media server. For the
Maximum concurrent drives used for backup, specify the
total number of all shared drives in the robot. When you
configure storage units, select a single media server.
Alternatively, you can allow NetBackup to select the media
server to use at the time of the backup. For example, you
can configure a single storage unit that any media server
that shares the storage unit can use.
Configuring storage units for
each media server
Configuring the Shared Storage Option
About configuring the Shared Storage Option in NetBackup
152
To Next Page
Loading...
