Table 11-2
Nirvanix initial configuration tasks (continued)
InstructionsTaskStep
If you want to add additional child accounts to the first disk pool you create,
Symantec recommends that you add them at this point of the configuration.
NetBackup creates a child account when you run the Disk Pool
Configuration Wizard. Therefore, that child account is not listed on the
Management Portal when you configure additional child accounts. It
becomes listed after you create the disk pool.
See “About multiple Nirvanix child accounts” on page 74.
You can add additional child accounts at any time. You can use them in a
new disk pool or merge them into an existing disk pool.
See “Merging OpenStorage disk pools” on page 118.
Optionally, configure
additional child accounts
Step 8
See “Configuring an OpenStorage disk pool” on page 89.Configure a disk poolStep 9
See “Configuring an OpenStorage storage unit” on page 91.Configure a storage unitStep 10
See the NetBackup Administrator's Guide for Windows, Volume I.
See the NetBackup Administrator's Guide for UNIX and Linux, Volume I.
Configure a policy that uses
the storage unit you
configured
Step 11
Creating NetBackup log file directories
Before you configure OpenStorage, create the directories into which NetBackup
commands write log files. Create the directories on the master server and on each
media server that you use for OpenStorage.
More information about NetBackup logging is available.
See the NetBackup Troubleshooting Guide.
See “About OpenStorage log files” on page 125.
To create log directories for NetBackup commands
◆
Depending on the operating system, run one of the following scripts:
UNIX: /usr/openv/netbackup/logs/mklogdir
Windows:install_path\NetBackup\logs\mklogdir.bat
Configuring OpenStorage
Creating NetBackup log file directories
84
To Next Page
Loading...
