Symantec NetBackup - Managing AdvancedDisk disk pools

Viewing AdvancedDisk storage servers
Use the NetBackup Administration Console to view a list of storage servers
already configured.
To view AdvancedDisk storage servers
◆
In the NetBackup Administration Console, in the left pane, expand Media
and Device Management > Credentials > Storage Server.
The right pane, labeled All Storage Servers , shows all configured storage
servers. AdvancedDisk storage servers show AdvancedDisk in the Disk Type
column.
Viewing AdvancedDisk storage server attributes
Use the NetBackup nbdevquery command to view the storage server attributes.
To view AdvancedDisk storage server attributes
◆
Run the following command on the NetBackup master server or a storage
server:
nbdevquery -liststs -storage_server storage_server -stype
AdvancedDisk –U
The following is the path to the nbdevconfig command:
■ UNIX: /usr/openv/netbackup/bin/admincmd
■ Windows: install_path\NetBackup\bin\admincmd
The following is example output:
Storage Server : advdsk_server.symantecs.com
Storage Server Type : AdvancedDisk
Storage Type : Formatted Disk, Direct Attached
State : UP
Flag : PrefRestore
This example output is shortened; more flags may appear in actual output.
Managing AdvancedDisk disk pools
After you configure AdvancedDisk, you can perform various tasks to manage your
AdvancedDisk disk pools.
See “Adding volumes to an AdvancedDisk disk pool” on page 41.
See “Changing AdvancedDisk disk pool properties” on page 41.
Managing AdvancedDisk
Managing AdvancedDisk disk pools
40