Use the Storage Server Configuration Wizard to configure a storage server.
However, if you want to configure preferred or required attributes, use the
nbdevconfig command.
You can configure multiple storage servers. If you do, you must run the wizard
for each storage server you want to configure. You must configure as storage
servers the NetBackup media servers that have read and write access to the storage.
See “About AdvancedDisk storage servers” on page 23.
When you configure a storage server, it also is configured as a data mover.
See “About AdvancedDisk data movers” on page 23.
See “About AdvancedDisk preferred or required read servers” on page 24.
To configure an AdvancedDisk storage server by using the wizard
1
Determine if the storage server is configured already.
See “Viewing AdvancedDisk storage servers” on page 40.
2
In the NetBackup Administration Console, in the left pane, expand Media
and Device Management > Configure Disk Storage Servers.
3
Follow the wizard screens to configure a storage server.
To configure an AdvancedDisk storage server with attributes
1
Determine if the storage server is configured already.
See “Viewing AdvancedDisk storage servers” on page 40.
2
Run the following command on the NetBackup master server or the media
server:
nbdevconfig -creatests -storage_server hostname -stype
AdvancedDisk [-st storage_type] -media_server hostname
[-setattribute attribute]
The following is the path to the nbdevconfig command:
■ UNIX: /usr/openv/netbackup/bin/admincmd
■ Windows: install_path\NetBackup\bin\admincmd
See “AdvancedDisk storage server options” on page 27.
AdvancedDisk storage server options
The following are the nbdevconfig command options that are used to configure
storage servers.
27Configuring AdvancedDisk
Configuring an AdvancedDisk storage server
To Next Page
Loading...
