Symantec NetBackup - Changing Openstorage Server Credentials; Deleting the Openstorage Server Credentials of a Data Mover

To add OpenStorage server credentials
1
In the NetBackup Administration Console, expand Media and Device
Management > Credentials > Storage Server.
2
Select the storage server, then select Edit > Change.
3
Select the Media Servers tab.
4
Select the media server you want to add. Also select the media servers that
are configured as data movers already.
5
Enter the credentials.
6
Click Set and then click OK.
Changing OpenStorage server credentials
You can change the credentials that the media servers that function as data movers
use. The credentials are for the storage server.
See “About OpenStorage server credentials” on page 61.
To change OpenStorage server credentials
1
In the NetBackup Administration Console, expand Media and Device
Management > Credentials > Storage Server.
2
Select the storage server, then select Edit > Change.
3
Select the Media Servers tab.
4
Select the media servers that function as data movers.
5
Change the credentials.
6
Click Set and then click OK.
Deleting the OpenStorage server credentials of a data mover
If you remove a media server as a data mover, you must delete the storage server
credentials of the media server.
If the host failed and is unavailable, you can use the tpconfig device configuration
utility in menu mode to delete the credentials. However, you must run the tpconfig
utility on a UNIX or Linux NetBackup server.
For procedures, see the NetBackup Administrator’s Guide for UNIX and Linux,
Volume II.
Managing OpenStorage
Managing OpenStorage server credentials
110