Table 12-2
Process to retire an OpenStorage data mover (continued)
WhereWhat
See “Deleting the OpenStorage server
credentials of a data mover ” on page 110.
On the media server to be retired, delete the
credentials for the storage server.
Managing OpenStorage disk pools
After you configure OpenStorage, you can perform various tasks to manage your
OpenStorage disk pools.
See “Adding volumes to an OpenStorage disk pool” on page 113.
See “Changing OpenStorage disk pool properties” on page 114.
See “Changing OpenStorage disk pool state” on page 115.
See “Changing OpenStorage disk volume state” on page 116.
See “Deleting an OpenStorage disk pool” on page 116.
See “Determining OpenStorage disk pool state” on page 117.
See “Determining OpenStorage disk volume state” on page 117.
See “Merging OpenStorage disk pools” on page 118.
See “Removing a volume from an OpenStorage disk pool” on page 119.
See “Updating an OpenStorage disk pool” on page 119.
See “Viewing OpenStorage disk pools” on page 120.
Adding volumes to an OpenStorage disk pool
If you add disk volumes to the storage appliance, NetBackup does not add those
volumes to an OpenStorage disk pool automatically. To use the additional disk
volumes in an existing disk pool, you must add those volumes to the disk pool.
(By default, NetBackup automatically increases disk pool capacity if the capacity
of the underlying disk volumes increases. Similarly, NetBackup decreases the
capacity of a disk pool if the underlying disk volume capacity decreases.)
The NetBackup storage units that use the disk pool automatically use the additional
storage capacity. You do not have to change the storage units.
113Managing OpenStorage
Managing OpenStorage disk pools
To Next Page
Loading...
