Symantec NetBackup - Removing Openstorage Storage Server Attributes; Setting Openstorage Storage Server Attributes

nbdevquery -liststs -stype server_type -storage_server server_name
-U
The following is the path to the nbdevconfig command:
■ UNIX: /usr/openv/netbackup/bin/admincmd
■ Windows: install_path\NetBackup\bin\admincmd
For the server_type, the storage vendor provides the string that identifies the
server type.
The State field shows either UP or DOWN.
Setting OpenStorage storage server attributes
You may have to set or clear attributes on your storage server. Usually, you set
attributes to add or remove functionality.
If you set attributes on the storage server, you also must set the same attributes
on the existing disk pools. Any disk pools that you create after you set attributes
on the storage server inherit the new functionality.
To set an OpenStorage storage server attribute
◆
Run the following command on the NetBackup master server or on a storage
server:
nbdevconfig -changests -storage_server hostname -stype server_type
-setattribute attribute
For hostname, use the name of the disk appliance host. For server_type, the
OpenStorage vendor provides the string that identifies their storage type.
For attribute, use the name of the attribute you want to set.
The following is the path to the nbdevconfig command:
■ UNIX: /usr/openv/netbackup/bin/admincmd
■ Windows: install_path\NetBackup\bin\admincmd
Removing OpenStorage storage server attributes
You may have to remove attributes from your storage server. Usually, you remove
attributes to change or remove functionality.
If you remove attributes on the storage server, you also must remove the same
attributes on the existing disk pools. Any disk pools that you create after you
update the storage server inherit the storage server functionality.
107Managing OpenStorage
Managing OpenStorage storage servers