By default, NetBackup automatically decreases disk pool capacity if you remove
a disk volume.
The following is the path to the nbdevconfig command:
■ UNIX: /usr/openv/netbackup/bin/admincmd
■ Windows: install_path\NetBackup\bin\admincmd
To remove a volume from an AdvancedDisk disk pool
1
Change the disk volume state to DOWN.
See “Changing AdvancedDisk disk volume state” on page 43.
2
Change the disk pool state to DOWN.
See “Changing AdvancedDisk disk pool state” on page 42.
3
Remove the volume by using the nbdevconfig command. The following is
the command syntax:
nbdevconfig -deletedv -stype AdvancedDisk -dp disk_pool_name –dv
vol_name
4
Change the disk pool state to UP.
See “Changing AdvancedDisk disk pool state” on page 42.
Viewing AdvancedDisk disk pools
Use the NetBackup Administration Console to view configured disk pools.
To view disk pools
◆
In the NetBackup Administration Console tree, in the left pane, select Media
and Device Management > Devices > Disk Pools.
The list appears in the right pane.
Monitoring AdvancedDisk storage capacity and usage
To monitor storage capacity and usage, see the following:
The Disk Pools window displays a value that was stored
when NetBackup polled the disk pools. The value may not
be as current as the value that is displayed in the Storage
Server window.
To display the window, select Media and Device
Management > Devices > Disk Pools.
The NetBackup
Administration Console Disk
Pools window.
Managing AdvancedDisk
Monitoring AdvancedDisk storage capacity and usage
46
To Next Page
Loading...
