Symmetricom TimeProvider 1000 Reference Guide

Appendix B Alarms
148 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
<aid> = PRS
INPDISQ The specified input was
Disqualified or Qualified
as a possible system
reference. The fault
condition must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPDISQ is set,
the alarm clears when
the input signal is fault
free for the Clear Delay
Time (CLRDELAY).
T1 NSA FLT
DELAY
YES MN MN MN
INPLOS The specified input port
has Loss Of Signal.
When LOS is detected,
the input is immediately
removed from the
possible reference list.
The LOS must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPLOS is set, the
alarm clears when the
input signal is LOS free
for the Clear Delay Time
(CLRDELAY).
T1 NSA IMMEDNO MNMNMN
Table B-1. Alarms (Continued)
Alarm ID
or
CONDTYPE
Alarm Condition
Description
AID
Type
Service
Affecting
Error
Delay
Default
Error
Delay
Editable
Alarm Default
Level
SSU PRS SUB

Symmetricom TimeProvider 1000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1000
Category	Clock
Language	English