097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 167
Appendix C Events
INPREF Indicates when the
system automatically
selects a new reference
input.
Allows the user to
manually select the input
to be used for the system
reference. The reference
selection mode
REFMODE must be set
to FORCED.
T1 PRS
PRS – Select PRS input
INP1 – Select Input 1
INP2 – Select Input 2
GPS is selected as system
reference only in PRR mode of
operation.
LOCTIM The system local time
offset was changed.
EQPT (00)-00
(hh) – Hours offset +/-12
mm – minutes offsegt 00 to 59
REFMODE Allows the system to
automatically select the
reference input or allow
the user to select the
reference.
EQPT AUTO
AUTO – System uses Qlevel
and Priority to select the
system reference.
FORCED – The user selects
the system reference, if the
selected reference fails the
system reverts to AUTO mode
for reference selection.
TIMCHG The system time was
changed.
EQPT hh-mm-ss
hh – Hours (24 hour clock)
mm – Minutes
ss – Seconds
UTC Indicates UTC time was
determined by GPS
interface.
EQPT hh-mm-ss hh-mm-ss
Retimer Event Codes
CKTIDCHG A user has modified the
Circuit ID for the output.
T1 GPS The ID can be up to 40 characters
in length.
FREEFLT Defines if the Retimer
mode operates or not
when the LO enters
Free-run mode of
operation. The output
groups are provisioned
for fault strategies.
T1 CUTTHRU
RETIMER – In fault mode the
output signals are retimed
CUTTHRU – In fault mode the
cut-thru mode is enabled, and
output signals are not retimed.
Table C-1. Event Identifiers (Continued)
Event ID
or
CONDTYPE
Event Description
AID
TYPE
Default Value Value Description
To Next Page
Loading...
Need help?
General
