Chapter 2 TL1 Command Syntax and Description
Edit Equipment (ED-EQPT)
48 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
CLKTYPE
ST2 /
TYPEII
Rubidium
The assumed SSM quality level for the Rubidium IOC
card’s clock is set to either ANSI stratum 2 traceable
(ST2) or ETSI Type 2 (TYPEII) traceable. This value is
used for placing SSM bits in the output stream when in
Holdover mode. Any input to the unit that is of lesser
quality than ST2 / TYPEII is not used as a reference.
Note: ST2 and TYPEII can only be provisioned on the
Rubidium IOC card; they cannot be provisioned on the
Quartz IOC card.
TYPEI /
TYPEII
ST3E /
TYPEI
Quartz
The assumed SSM quality level for the Quartz IOC card’s
clock is set to either ETSI Type 1 (TYPEI) or ANSI
(ST3E). This value is used for placing SSM bits in the
output stream when in Holdover mode. Any input to the
unit that is of lesser quality than TYPEI / ST3E is not used
as a reference.
Note: ST3E and TYPEI can only be provisioned on the
Quartz IOC card; they cannot be provisioned on the
Rubidium IOC card.
IOCSTATE INSRV
The IOC card is placed into service. INSRV
OOSRV
The IOC card is taken out of service.
Note: A module that was taken out of service is not
selectable by the system to generate outputs or monitor
inputs, and no alarms are generated by the module.
<aid> = GPS
INSTATE ENABLE The specified input is enabled. DISABLE
DISABLE The specified input is disabled.
MONITOR
The specified input is in monitor-only mode.
Note: In monitor-only mode, the performance of the input
is monitored and it is monitored for signal faults, but
cannot be selected as a system reference.
MODE AUTO The antenna position (latitude, longitude, and height) is
automatically computed or re-computed and then set.
AUTO
MANUAL The user sets the antenna position (latitude, longitude,
and elevation) using the POS keyword.
POS
Note: The
position can
only be set
when MODE =
Manual.
LAT dd-mm-ss.ssN or dd-mm-ss.ssS N/A
LONG dd-mm-ss.ssE or dd-mm-ss.ssW
ELEV ±hhhh.h elevation (altitude) in meters
ELEVMASK 5° to 45° The specified elevation mask. 10°
Table 2-5. ED-EQPT – Keywords and Values (Continued)
<keyword> <value> Description Default
To Next Page
Loading...
Need help?
General
